Your water heater is one of the used and much more costly appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving from the home heating as well as costs.
Regular flushing of your water heater has become single most important step you consider to prolong its service life in addition, it save energy. For time, sediments strengthen in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not merely destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regarding the country, the common water heater lasts 3-5 years. Regularly flushing your water heater can double daily life of your hot water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is in today’s economy. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a nights.
To drain your water heater, initially you should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is electric heater). Failure to do so could result in overheating and severe damage to the heater. Next, close the water supply valve located over the water inlet line going into your water heater. After backing up connect a hose to the drain valve located at the base of the heater tank. Open the drain and allow it to move until all for the water has emptied from the air conditioner. Then close the drain. Open the water supply valve and refill the central heater. You should also open a hot water faucet somewhere inside the house and stand there and watch it run for several minutes until the water flows out perfectly. This will allow air to vent off of the heater and the hot water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so may less corrosive to your plumbing system, particularly in areas possess hard water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in place to discuss options and products to work for you.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610